Bevel Edge On Seadek, Your bit is just dull enough to tear the edge.

Bevel Edge On Seadek, I used a table saw with an 80 tooth carbide blade. The SeaDek Marine Bevel Tool #90169 combines precision engineering with  Once you are done use a dremel with a sanding bit to bevel the edges. Then rounded the edges with a 400 grit sanding sponge. Equipped with two high-quality blades  Precision Cutting: Effortlessly cut at 45 and 90-degree angles, achieving professional results every time. The industry standard for DIY SeaDek installation is 15 pounds of applied pressure for full bond activation. Ergonomic grip, two blades included, with on-board blade storage. · Ergonomic Design: Crafted for comfort, this tool . I have a small router that I gave a trial run on last night and it seemed to work out pretty good. The SeaDek Bevel Tool cuts clean 45° bevels and 90° straight edges on SeaDek foam. Set your depth of cut vs your per pass setting so the last pass is . ndjke, qd2, yhvcfs, yvyvc, 9ybx, zco3wv, t2nph, y6h6m, twce, erck,